24 snmp-server community ro, 25 snmp-server community rw, 26 snmp-server enable traps – PLANET WGS3-24240 User Manual
Page 385: 27 snmp-server enable traps bcaststorm
User’s Manual of WGS3-24000 / WGS3-24240
385
8.5.23.1 no snmp-server community mode
This command deactivates an SNMP community. If the community is disabled, no SNMP requests using this community are
accepted. In this case the SNMP manager associated with this community cannot manage the switch until the Status is
changed back to Enable.
▫
Format no snmp-server community mode
▫
Mode
Global Config
8.5.24 snmp-server community ro
This command restricts access to switch information. The access mode is read-only (also called public).
▫
Format snmp-server community ro
▫
Mode
Global Config
8.5.25 snmp-server community rw
This command restricts access to switch information. The access mode is read/write (also called private).
▫
Format snmp-server community rw
▫
Mode
Global Config
8.5.26 snmp-server enable traps
This command enables the Authentication Flag.
▫
Default Enabled
▫
Format snmp-server enable traps
▫
Mode
Global Config
8.5.26.1 no snmp-server enable traps
This command disables the Authentication Flag.
▫
Format no snmp-server enable traps
▫
ModeGlobal Config
8.5.27 snmp-server enable traps bcaststorm
This command enables the broadcast storm trap. When enabled, broadcast storm traps are sent only if the broadcast storm
recovery mode setting associated with the port is enabled.
▫
Default Enabled
▫
Format snmp-server enable traps bcaststorm
▫
Mode
Global Config
8.5.27.1 no snmp-server enable traps bcaststorm
This command disables the broadcast storm trap. When enabled, broadcast storm traps are sent only if the broadcast storm