20 snmp-server community – PLANET WGS3-24240 User Manual
Page 383
User’s Manual of WGS3-24000 / WGS3-24240
383
receivers. The switch does not have to be reset to implement the changes. Cold and warm start traps are always generated and
cannot be disabled.
▫
Format show trapflags
▫
Mode
Privileged EXEC
▫
Authentication Flag - May be enabled or disabled. The factory default is enabled. Indicates whether authentication
failure traps will be sent.
▫
Link Up/Down Flag - May be enabled or disabled. The factory default is enabled. Indicates whether link status traps
will be sent. Multiple Users Flag.
▫
Multiple Users Flag - May be enabled or disabled. The factory default is enabled. Indicates whether a trap will be sent
when the same user ID is logged into the switch more than once at the same time (either via telnet or serial port).
▫
Spanning Tree Flag - May be enabled or disabled. The factory default is enabled. Indicates whether spanning tree traps
will be sent.
▫
Broadcast Storm Flag - May be enabled or disabled. The factory default is enabled. Indicates whether broadcast storm
traps will be sent.
▫
DVMRP Traps - May be enabled or disabled. The factory default is disabled. Indicates whether DVMRP traps will be sent.
▫
OSPF Traps - May be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps will be sent.
▫
PIM Traps - May be enabled or disabled. The factory default is disabled. Indicates whether PIM traps will be sent.
8.5.20 snmp-server community
This command adds (and names) a new SNMP community. A community name is a name associated with the switch and with a
set of SNMP managers that manage it with a specified privileged level. The length of name can be up to 16 case-sensitive
characters.
Community names in the SNM
P community table must be unique. If you make multiple entries using the same community
name, the first entry is kept and processed and all duplicate entries are ignored.
▫
Default Two default community names: Public and Private. You can replace these default community names with
unique identifiers for each community. The default values for the remaining four community names are blank.
▫
Format snmp-server
community
▫
Mode
Global Config
8.5.20.1 no snmp-server community
This command removes this community name from the table. The name is the community name to be deleted.
▫
Format no snmp-server community
▫
Mode
Global Config