PLANET WGS3-24240 - Manual (Page 495)

User’s Manual of WGS3-24000 / WGS3-24240
495
12.7 Open Shortest Path First (OSPF) Commands
This section describes the commands you use to view and configure OSPF, which is a link-state routing protocol that you use to
route traffic within a network.
12.7.1 router ospf
Use this command to enter Router OSPF mode.
▫ Format router ospf
▫ Mode Global Config
12.7.2 enable (OSPF)
This command resets the default administrative mode of OSPF in the router (active).
▫ Default enabled
▫ Format enable
▫ Mode Router OSPF Config
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
▫ Format no enable
▫ Mode Router OSPF Config
12.7.3 ip ospf
This command enables OSPF on a router interface.
▫ Default disabled
▫ Format ip ospf
▫ Mode Interface Config
no ip ospf
This command disables OSPF on a router interface.
▫ Format no ip ospf
▫ Mode Interface Config
12.7.4 1583compatibility
This command enables OSPF 1583 compatibility.
NOTE: 1583 compatibility mode is enabled by default. If all OSPF routers in the routing domain are capable of operating