PLANET WGS3-24240 - Manual (Page 395)

User’s Manual of WGS3-24000 / WGS3-24240
395
▫ Default none
▫ Format protocol vlan group
▫ Mode Interface Config
8.6.20.1 no protocol vlan group
This command removes the from this protocol-based VLAN group that is identified by this . If is
selected, all ports will be removed from this protocol group.
▫ Format no protocol vlan group
▫ Mode Interface Config
8.6.21 protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by . A group may have more than
one interface associated with it. Each interface and protocol combination can only be associated with one group. If adding an
interface to a group causes any conflicts with protocols currently associated with the group, this command will fail and the
interface(s) will not be added to the group.
▫ Default none
▫ Format protocol vlan group all
▫ Mode Global Config
8.6.21.1 no protocol vlan group all
This command removes all interfaces from this protocol-based VLAN group that is identified by this .
▫ Format no protocol vlan group all
▫ Mode Global Config
8.6.22 set garp timer join
This command sets the GVRP join time per port and per GARP. Join time is the interval between the transmission of GARP
Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds)
▫ Default 20 centiseconds (0.2 seconds)
▫ Format set garp timer join <10-100>
▫ Mode Interface Config
8.6.22.1 no set garp timer join
This command sets the GVRP join time per port and per GARP to 20 centiseconds (0.2 seconds). This command has an effect
only when GVRP is enabled.
▫ Format no set garp timer join
▫ Mode Interface Config