HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 84)

68 4 Programmieren: Grundlagen, Datei-Verwaltung,
Programmierhilfen, Paletten-Verwaltung
4.8 Adding Comments
You can add comments to any desired block in the
part program to explain program steps or make
general notes. There are three possibilities to add
comments:
1. Adding comments during program input (not
TNC 410)
ú Enter the data for a program block, then press the
semicolon key “;” on the alphabetic keyboard —
the TNC displays the dialog prompt
COMMENT ?
ú Enter your comment and conclude the block by
pressing the END key.
2. Adding comments after program input
(not TNC 410)
ú Select the block to which a comment is to be
added.
ú Move to the required block using the arrow keys,
then press the semicolon key on the alphabetic
keyboard _ the TNC displays the dialog prompt
COMMENT ?
ú Enter your comment and conclude the block by
pressing the END key.
3. To enter a comment in a separate block:
ú Select the block after which the comment is to be
inserted.
ú Initiate the programming dialog with the
semicolon key “;” on the alphabetic keyboard.
ú Enter your comment and conclude the block by
pressing the END key.
4.8 A
dding Comments
Ekap4.pm6 29.06.2006, 08:06 68