HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 315)

12 3-D Touch Probes 300
Displaying calibration values
The TNC stores the effective length and radius, and
the center misalignment for use when the touch
probe is needed again. You can display the values
on the screen with the soft keys CAL L and CAL R.
Storing calibration values in the TOOL.T tool table
(not TNC 410)
This function is only available if machine
parameter 7411 = 1 is set (Activate touch
probe data with tool call T).
If you record measurements during program run,
the compensation data for the touch probe can be
activated from the tool table via a tool call T. To store
the calibration data in the TOOL.T tool table, enter
the tool number in the calibration menu (confirm
with ENT) and then press the ENTER R IN TOOL
TABLE or the ENTER L IN TOOL TABLE soft key.
12.1 T
o
u
c
h
P
robe Cy
cles in the Manual and Electr
onic Handwheel
Okap12.pm6 29.06.2006, 08:06 300