HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 356)

HEIDENHAIN TNC 410, TNC 426, TNC 430 341
14.1 Gener
al User P
ar
amet
ers
Measuring rotating tools: Permissible rotational speed at the circumference of the milling tool
Required for calculating rpm and probe feed rate
MP6570
1.000 to 120.000 [m/min]
Coordinates of the TT 120 stylus center relative to the machine datum
MP6580.0 (traverse range 1)
X axis
MP6580.1 (traverse range 1)
Y axis
MP6580.2 (traverse range 1)
Z-axis
MP6581.0 (traverse range 2) (not TNC 410)
X-axis
MP6581.1 (traverse range 2) (not TNC 410)
Y-axis
MP6581.2 (traverse range 2) (not TNC 410)
Z-axis
MP6582.0 (traverse range 3) (not TNC 410)
X-axis
MP6582.1 (traverse range 3) (not TNC 410)
Y-axis
MP6582.2 (traverse range 3) (not TNC 410)
Z-axis
TNC displays, TNC editor
Programming station
MP7210
TNC with machine: 0
TNC as programming station with active PLC: 1
TNC as programming station with inactive PLC: 2
Acknowledgment of POWER INTERRUPTED after switch-on
MP7212
Acknowledge with key: 0
Acknowledge automatically: 1
ISO programming: Set the block number increment
MP7220
0 to 150
Rkap14.pm6 29.06.2006, 08:07 341