HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 25)

9 HEIDENHAIN TNC 410, TNC 426, TNC 430
1.4 Status Displays
“General” status display
The status display informs you of the current state of the machine
tool. It is displayed automatically in the following modes of
operation:
■ Program Run, Single Block and Program Run, Full Sequence,
except if the screen layout is set to display graphics only, and
■ Positioning with Manual Data Input (MDI).
In the operating modes Manual and Electronic Handwheel, the
status display is shown in the large window.
Information in the status display
The Meaning
ACTL. Actual or nominal coordinates of the current position
X Y Z Machine axes; the TNC displays auxiliary axes in
lower-case letters. The sequence and quantity of displayed
axes is determined by the machine tool builder.
Refer to your machine manual for more information
F S M The displayed feed rate in inches corresponds to
one tenth of the effective value.
Spindle speed S, feed rate F and active M functions
Program run started
# Axis locked
Axis can be moved with the handwheel
Axes are moving in a tilted working
plane (not TNC 410)
Axes are moving under a basic
rotation
1
.4 Stat
us Displa
ys
Dkap1.pm6 29.06.2006, 08:05 9