HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 76)

60 4 Programming: Fundamentals of NC, File Management,
Programming Aids, Pallet Management
Opening a new part program TNC 426, TNC 430
You always enter a part program in the Programming and Editing
mode of operation.
Program initiation in an example:
Select the Programming and Editing mode of
operation.
<
To call the file manager, press the PGM MGT
key.
<
Select the directory in which you wish to store the new program
File name = OLD.I
<
NEW Enter the new program name and confirm your
entry with the ENT key.
To select the unit of measure, press the MM or
INCH soft key. The TNC changes to the program
window
4.6 Cr
eating and
W
riting Pr
ogr
ams
Open new program for the TNC 410
You always enter a part program in the Programming
and Editing mode of operation.
Program initiation in an example:
Select the Programming and
Editing mode of operation.
<
To call the file manager, press
the PGM MGT key.
File name =
<
NEW Entering new program names
<
Select the file type, e.g. ISO
program: Press the .I soft key.
If necessary, switch to inches as
unit of measure: Press the MM/
INCH soft key.
<
Confirm your entry with the ENT
key.
Ekap4.pm6 29.06.2006, 08:06 60