HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 308)

HEIDENHAIN TNC 410, TNC 426, TNC 430 293
11.6 Optional block skip
In a test run or program run, the TNC can skip over blocks that begin
with a slash (/):
ú To run or test the program with the blocks
preceded by a slash, set the soft key to OFF
ú To run or test the program without the blocks
preceded by a slash, set the soft key to ON
This function does not work for TOOL DEF blocks.
After a power interruption the TNC returns to the most
recently selected setting.
11.7 Optional Program Run Interruption
(not TNC 426, TNC 430)
The TNC optionally interrupts the program or test run at blocks
containing M01. If you use M01 in the Program Run mode, the TNC
does not switch off the spindle or coolant.
ú Do not interrupt program run or test run at blocks
containing M01: Set soft key to OFF
ú Interrupt program run or test run at blocks containing
M01: Set soft key to ON
11
.6 Optional Bloc
k Skip;
1
1
.7 Optional Pr
ogr
am Int
er
ruption (not
TNC 426,
TNC 430)
Nkap11.pm6 29.06.2006, 08:06 293