HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 355)

14 Tabellen und Übersichten 340
14.1 Gener
al User P
ar
amet
ers
Target window for digitizing contour lines with a measuring touch probe (not TNC 410)
When you are digitizing contour lines the
individual contour lines do not end exactly in their
starting points.
With machine parameter MP6390 you can define
a square target window within which the end
point must lie after the touch probe has orbited
the model. Enter half the side length of the target
window for the side length.
MP6390
0.1 to 4.0000 [mm]
Radius measurement with the TT 120 touch probe: Probing direction
MP6505.0 (traverse range 1) to 6505.2 (traverse range 3)
Positive probing direction in the angle reference axis (0° axis): 0
Positive probing direction in the +90° axis: 1
Negative probing direction in the angle reference axis (0° axis): 2
Negative probing direction in the +90° axis: 3
Probing feed rate for second measurement withTT 120, stylus shape, corrections in TOOL.T
MP6507
Calculate feed rate for second measurement with TT 120,
with constant tolerance: +0
Calculate feed rate for second measurement with TT 120,
with variable tolerance: +1
Constant feed rate for second measurement with TT 120: +2
Maximum permissible measuring error with TT 120 during measurement with rotating tool
Required for calculating the probing feed rate in
connection with MP6570
MP6510
0.001 to 0.999 [mm]
(recommended input value: 0.005 mm)
Feed rate for probing a stationary tool with the TT 120
MP6520
10 to 3000 [mm/min]
Radius measurement with the TT 120: Distance from lower edge of tool to upper edge of stylus
MP6530.0 (traverse range 1) to MP6530.2 (traverse range 3)
TNC 410: 1 traverse range
Clearance zone around the stylus of the TT 120 for pre-positioning
MP6540
0.001 to 99,999.999 [mm]
Rapid traverse for TT 120 in the probe cycle
MP6550
10 to 10 000 [mm/min]
M function for spindle orientation when measuring individual teeth
MP6560
0 to 88
Rkap14.pm6 29.06.2006, 08:07 340