HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 302)

HEIDENHAIN TNC 410, TNC 426, TNC 430 287
1
1
.4 Pr
ogr
am Run
Moving the machine axes during an interruption
You can move the machine axes during an interruption in the same
way as in the Manual Operation mode.
TNC 426, TNC 430: Caution - Risk of collision!
If you interrupt program run while the working plane is
tilted, you can change from a tilted to a non-tilted
coordinate system, and vice versa, by pressing the 3-D
ON/OFF soft key.
The functions of the axis direction buttons, the electronic
handwheel and the positioning logic for return to
contour are then evaluated by the TNC. When retracting
the tool make sure the correct coordinate system is
active and the angular values of the tilt axes are entered
in the 3-D ROT menu.
Example:
Retracting the spindle after tool breakage
ú Interrupting machining
ú Enable the external direction keys: Press the MANUAL OPERATI-
ON soft key.
ú Move the axes with the machine axis direction buttons.
Use the function „Returning to the Contour“ (see below) to return
to a contour at the point of interruption.
For the TNC 426, TNC 430:
On some machines you may have to press the machine
START button after the MANUAL OPERATION soft key to
enable the axis direction buttons. Your machine manual
provides more detailed information.
Nkap11.pm6 29.06.2006, 08:06 287