HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 298)

HEIDENHAIN TNC 410, TNC 426, TNC 430 283
11
.3
T
est
Run
Running a program test up to a certain block
With the STOP AT N function the TNC does a test
run up to the block with block number N.
ú Go to the beginning of program in the Test Run
mode of operation.
ú To do a test run up to a certain block, press the
STOP AT N soft key.
ú Stop at N: Enter the block number at
which you wish the test to stop.
ú Program: If you wish to go into a
program that you call with CALL PGM,
enter the name of the program
containing the block with the selected
block number.
ú Repetitions: If N is located in a pro-
gram section repeat, enter the number
of repeats that you want to run.
ú To test a program section, press the
START soft key. The TNC will test the
program up to the entered block.
Nkap11.pm6 29.06.2006, 08:06 283