HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 22)

6 1 Introduction
Positioning with Manual Data Input
(MDI)
This mode of operation is used for programming
simple traversing movements, such as for face
milling or pre-positioning.
Soft keys for selecting the screen layout
Screen windows Soft key
Program
Left: positions. Right: status display.
(only TNC 426, TNC 430)
Left: program. Right: general program
information (only TNC 410)
Left: program. Right: positions and
coordinates (only TNC 410)
Left: program. Right: information on
tools (only TNC 410)
Left: program. Right: coordinate
transformations (only TNC 410)
1
.3 Modes of Oper
ation
Dkap1.pm6 29.06.2006, 08:05 6