HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 366)

HEIDENHAIN TNC 410, TNC 426, TNC 430 351
Running pallet tables (not TNC 410)
MP7683
Program run, single block: Run one line of the active NC program at
every NC start: +0
Program run, single block: Run the entire NC program at every NC
start: +1
Program run, full sequence: Run the entire NC program at every NC
start: +0
Program run, full sequence: Run all NC programs up to the next pallet
at every NC start: +2
Program run, full sequence: Run the entire NC program at every NC
start: +0
Program run, full sequence: Run the entire pallet file at every NC start: +4
Electronic handwheels
Handwheel type
MP7640
Machine without handwheel: 0
HR 330 with additional keys _ the handwheel keys for traverse
direction and rapid traverse are evaluated by the NC: 1 (not TNC 410)
HR 130 without additional keys: 2 (not TNC 410)
HR 330 with additional keys _ the handwheel keys for traverse
direction and rapid traverse are evaluated by the PLC: 3 (not TNC 410)
HR 332 with twelve additional keys: 4
(not TNC 410)
Multi-axis handwheel with additional keys: 5
HR 410 with miscellaneous functions: 6
Subdivision factor (not TNC 410)
MP7641
Interpolation factor is entered on the keyboard: 0
Interpolation factor is set by the PLC: 1
Machine functions that can be set for the handwheel by the machine tool builder (not TNC 410)
MP 7645.0 0 to 255
MP 7645.1 0 to 255
MP 7645.2 0 to 255
MP 7645.3 0 to 255
MP 7645.4 0 to 255
MP 7645.5 0 to 255
MP 7645.6 0 to 255
MP 7645.7 0 to 255
14.1 Gener
al User P
ar
amet
ers
Rkap14.pm6 29.06.2006, 08:07 351