HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 103)

87 HEIDENHAIN TNC 410, TNC 426, TNC 430
Abbr. Input
P Pocket number of the tool in the tool magazine
T Tool number
ST Special tool with a large radius requiring several pockets
in the tool magazine.
If your special tool takes up pockets in front of
and behind its actual pocket, these additional
pockets need to be locked (status L).
F Fixed tool number.
The tool is always returned to the same pocket.
L Locked pocket
PLC Information on this tool pocket that is to be sent to the PLC
TNAME Display of the tool name from TOOL.T
(only NC software 280 474-xx)
Dialog
–
Tool number ?
Special tool Yes = ENT / No = NO ENT
TNC 410: Special tool?
Fixed pocket Yes = ENT / No = NO ENT
TNC 410: Fixed pocket?
Pocket locked Yes = ENT / No = NO ENT
TNC 410: Pocket locked?
PLC status?
–
5.2 T
ool D
ata
Fkap5.pm6 29.06.2006, 08:06 87