HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 360)

HEIDENHAIN TNC 410, TNC 426, TNC 430 345
Configure pocket tables; Column number in the tool table for (to omit from table enter 0):
MP7267.0
Tool number — T: 0 to 5
MP7267.1
Special tool — ST: 0 to 5
MP7267.2
Fixed pocket — F: 0 to 5
MP7267.3
Pocket locked — L: 0 to 5
MP7267.4
PLC status — PLC: 0 to 5
Manual Operation mode: Display of feed rate
MP7270
Display feed rate F only if an axis direction button is pressed: 0
Display feed rate F even if no axis direction button is pressed (feed
rate defined via soft key F or feed rate of the „slowest“ axis): 1
Spindle speed S and miscellaneous function M effective after
STOP: +0
Spindle speed S and miscellaneous function M no longer effective after
STOP: +2
Decimal character
MP7280
The decimal character is a comma: 0
The decimal character is a point: 1
Position display in the tool axis
MP7285
Display is referenced to the tool datum: 0
Display in the tool axis is referenced to the tool face: 1
Display step for the X axis
MP7290.0
0.1 mm: 0
0.05 mm: 1
0.001 mm: 4
0.01 mm: 2 0.0005 mm: 5 (not TNC 410)
0.005 mm: 3 0.0001 mm: 6 (not TNC 410)
Display step for the Y axis
MP7290.1
For input values, see MP7290.0
Display step for the Z axis
MP7290.2
For input values, see MP7290.0
Display step for the IVth axis
MP7290.3
For input values, see MP7290.0
14.1 Gener
al User P
ar
amet
ers
Rkap14.pm6 29.06.2006, 08:07 345