HEIDENHAIN TNC 426B (280 472) ISO programming - Manual (Page 334)

HEIDENHAIN TNC 410, TNC 426, TNC 430 319
ASSIGN
This function sets the destination for the transferred data.
Applications:
• Transferring values with Q parameter function D15
• Path on the TNC’s hard disk in which the digitized data are stored
The TNC mode of operation determines whether the PRINT or
PRINT TEST function is used:
TNC mode of operation Transfer function
Program Run, Single Block PRINT
Program Run, Full Sequence PRINT
Test run PRINT TEST
You can set PRINT and PRINT TEST as follows:
Function Path
Output data via RS-232 RS232:\....
Output data via RS-422 RS422:\....
Save data to the TNC’s hard disk TNC:\....
Save data in directory in which the program
with D15 or the program with the
digitizing cycles is located
- vacant -
File names
Data Operating mode File name
Digitizing data Program Run Defined in the RANGE
cycle
Values with FN15 Program Run %D15RUN.A
Values with FN15 Test run %D15SIM.A
13.6 Set
ting Up the D
ata Int
erf
aces f
o
r
TNC 426,
TNC 430
Pkap13.pm6 29.06.2006, 08:06 319