H3C Technologies H3C S9500 Series Switches - Manual (Page 96)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 4 Switch Installation
4-27
Plug the DB-9 (male) connector at the other end into the serial port of the analog
modem.
4.11.3 Connecting Category-5 Shielded Cable
I. I oduction to RJ-4 nector
Being RJ-45 connecto 10Base-T/100B e-TX port of the S9500 series supports
ill be connected using the category-5 shielded cable.
tes an RJ-45 connector.
ntr 5 con
r, the as
MDI/MDIX auto-sensing and w
The following figure illustra
PIN #8
igure 4-29 RJ-45 connector
II ng category-5 shielded cable
4.11.4 Co
PIN # 1
F
. Connecti
Step 1: Plug one end of the network cable into the desired Ethernet RJ-45 connector on
the switch.
Step 2: Plug the other end of the cable into the RJ-45 port of the peer device.
nnecting Fiber
Note:
All the megabit and gigabit optical modules available for the S9500 series are SFP
modules that provide LC user ports.
I. Introduction to fiber connector