H3C Technologies H3C S9500 Series Switches - Manual (Page 22)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 1 Product Overview
1-16
Table 1-14 Status LEDs for the SRP1N4 module
SRP1N4 LED Status
ON The switching fabric unit is active.
SFS
OFF The switching fabric unit is standby.
Green The SRP1N4 module is faulty.
OFF The SRP1N4 module is faulty. RUN
Green blinking The SRP1N4 module runs normally.
Red The SRP1N4 module has alarms.
ALM
OFF The SRP1N4 module has no alarms.
Green The SRP1N4 module is active.
ACT
OFF The SRP1N4 module is standby.
II. SRP1N5 module
1) Specifications
The S9508 uses SRP1N5 modules. The following table summarizes the board
specifications.
Table 1-15 SRP1N5 module specifications
Attribute SRP1N5
CPU MPC755
Boot ROM 512 KB
SDRAM 512 MB (expandable to 1 GB)
Dimensions (L × W) 366.7 × 340 mm (14.4 × 13.4 in.)
Port
One Console port, for local configuration management
One AUX port, for remote dialup configuration management
One 10Base-T/100Base-TX port for system management
and program upgrade
One RS232/485 port, for connecting external PoE power
frame when supported
One hot-swappable CF port
Max. power
consumption
60 W
2) SRP1N5 panel
The SRP1N5 module provides CF port, CF LED (CFS), 10Base-T/100Base-TX port,
RS232/485 port, Console port, AUX port, RESET button, LPU status LEDs, SRP1N5
status LEDs (SFS, ACT, ALM, RUN), as shown in Figure 1-12.