H3C Technologies H3C S9500 Series Switches - Manual (Page 29)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 1 Product Overview
1-23
z
AUX port
The AUX port uses an RJ-45 connector. The port can serve as a backup port for the
Console port to connect a background terminal, or directly connect a modem device,
for remote system debugging, configuration, maintenance and management.
Table 1-29 AUX port specifications
Attribute Description
Connector RJ-45
Standard Asynchronous EIA/TIA-232
Service
Connects a serial port of a PC (through a Modem pair for a
remote PC) and runs terminal emulation on the PC.
4) RESET button
You can press the RESET button on the panel to reset the SRP1N6 module.
5) Status LEDs
z
CF status LED
You can check operating status of the CF card by reading the CF status LED on the
panel.
Table 1-30 CF status LED
LED Status
ON
The CF card is in position and is idle. You cannot remove
the card.
Blinking
The CF card is in position and reading/writing data. You
cannot remove the card.
CFS
OFF
The CF card is out of position or offline (you can force the
in-position CF card to go offline using the appropriate
background command). You can remove/insert the card.
z
Status LEDs for LPU modules
The SRP1N6 module has five pairs of LEDs to indicate the operating status of five LPU
modules.