H3C Technologies H3C S9500 Series Switches - Manual (Page 131)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 6 Switch Monitoring and Maintenance
6-22
Step 2: Specify the next boot program. If the switch has two SRPUs, specify the load
programs respectively for the active and standby SRPUs. Suppose the current standby
SRPU is at slot 7.
z Load Boot ROM program
boot bootrom flash:/Switchbtm.btm slot 6
boot bootrom slot7#flash:/Switchbtm.btm slot 7
z Load host program
boot boot-loader flash:/SWITCH002.app
boot boot-loader slot7#flash:/SWITCH002.app
Note:
The URL form of the files in the standby SRPU file system must start with
“slot[No.]#flash:/”, where [No.] is the standby SRPU number.
display boot-loader
The app to boot of board 6 at the next time is: flash:/SWITCH002.app
The app to boot of board 6 at this time is: flash:/SWITCH002.app
The app to boot of board 7 at the next time is: flash:/SWITCH002.app
The app to boot of board 7 at this time is: flash:/SWITCH002.app
reboot
Caution:
z You must reboot the switch using the reboot command to validate the host program.
If Flash memory space is not enough, you can delete some of the program files in
Flash after completing the Boot ROM loading. (You are recommended to delete the
host program that is no longer in use.) Then upload the host program to the switch
using FTP.
z Make sure that you have saved other configurations before rebooting; otherwise,
they might not survive a reboot.
z Power-off is forbidden during loading process.
Boot ROM and host program loading is completed now.
II. Remote and local loading using TFTP
Using TFTP is similar to using FTP in remote and local loading via commands. The only
difference is that you use the tftp get command to download software to the switch. In