H3C Technologies H3C S9500 Series Switches - Manual (Page 23)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 1 Product Overview
1-17
Figure 1-12 SRP1N5 panel
3) User ports
z
CF port
The SRP1N5 module provides a CF port to accommodate a standard CF card, where
you can save logging information, host version information, alarming and other
diagnostic information and conveniently upgrade software online.
z
Management 10Base-T/100Base-TX port
The management 10Base-T/100Base-TX port uses an RJ-45 connector. It can connect
a background terminal for system program loading and debugging, or connect a
network management station for remote system management.
Table 1-16 Management 10Base-T/100Base-TX port specifications
Attribute Description
Connector RJ-45
Number of ports One
Rate
10 Mbps, half duplex/full duplex
100 Mbps, half duplex/full duplex
Max. transmission segment
over the selected medium 100 m (328 ft) over the category-5 twisted pair cable
(crossover cable is required.)
Service System program upgrade and network management
The following table describes the status LEDs for the management
10Base-T/100Base-TX port.
Table 1-17 Status LEDs for the management 10Base-T/100Base-TX port
LED Status
OFF No link is present.
LINK
Green A link is present.
OFF No packets are transmitted/received on the port.
ACT
Blinking Packets are being transmitted/received on the port.
z
RS232/485 port
The RS232/485 port uses RJ-45 connector, for connecting external PoE power frame
when supported and monitoring its status.