H3C Technologies H3C S9500 Series Switches - Manual (Page 139)

Installation Manual
H3C S9500 Series Routing Switches
Appendix A Engineering Labels for Cables
A-5
z When the cells are merged and the printouts are made in multiple lines, avoid
covering the mark “TO” when printing the texts by using the space bar to move the
printing contents to the next line.
A.1.4 Writing Labels
Use the black oiliness markers to write the labels.
In special cases, black ball-pens are allowed, although not recommended. When
writing with the ball-pen, take care not to leave the oil on the label, which may
contaminate the label and blur the words..
Note:
The delivered marker has two nibs. Make sure to use the smaller nib to write the labels.
For the sake of easy recognition and good looking, the font in handwriting should be
close to the standard typeface as much as possible. Table A-1 shows the standard
typeface.
Table A-1 Standard typeface for handwriting
0 1 2 3 4 5 6 7 8
9 A B C D E F G H
I J K L M N O P Q
R S T U V W X Y Z
Write the characters in proper size, and the direction is as shown in Figure A-4:
TO:
Figure A-4 Writing direction of the label
A.1.5 Affixing Labels
After printing or writing the label, remove the label from the bottom page and affix it to
the signal cable, or the identification plate of the power cable.