H3C Technologies H3C S9500 Series Switches - Manual (Page 93)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 4 Switch Installation
4-24
Caution:
In ca
prod labels.
se of bodily injuries, do not touch any naked wire, terminal or other parts of the
uct with hazardous voltage
cont
Step ection (just check the direction of instructional words,
ug of the fan tray cannot touch the right socket
d on its handle and the other hand at its bottom the
anel of the fan tray with a screw driver.
Step 1: Wear the ESD-preventive wrist strap, making sure that it makes good skin
act; take the fan tray out from the packing bag.
2: Hold the fan tray in right dir
and if you insert it upside down, the pl
inside the chassis), with one han
ejector levers on the fan tray with both hands and pull them outward. Align the fan tray
with the guides in the chassis and slide it gently into the slot until its plug touches the
chassis socket.
Step 3: Fasten the mounting screws on the p
Note:
The above installation steps are just for replacing your fan tray, since the fan tray is
llation is required. delivered together with the chassis and no initial insta
alling LPU
The LPUs of the S9500 series are hot-swappable.
Step 1: Wear the ESD-preventive wrist strip, makin
Take the LPU out of the packing bag.
Step 2: Unscrew the mounting screws holding the blank filler p
you plan to install the LPU, and remove the pa
4.10 Inst
g sure that you have grounded it well.
anel in the slot where
nel from the slot.
Step 3: Hold the ejector levers on the fan tray with both hands and pull them outward.
sis and slide it gently into the slot until the
positioning pin of the LPU touches the hole in the chassis.
vers inward, locking the positioning pin into the hole.
the mounting screws on the LPU with a screw driver.
Align the LPU with the guides in the chas
Step 4: Pull the ejector le
Step 5: Fix the LPU by fastening