H3C Technologies H3C S9500 Series Switches - Manual (Page 128)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 6 Switch Monitoring and Maintenance
6-19
Write flash...done!
Step 6: After you provide the required information, the system accesses the Ethernet
interface submenu again:
ETHERNET SUBMENU
1. Download file to SDRAM through ethernet interface and boot
2. Download file to Flash through ethernet interface
3. Download file to HardDisk through ethernet interface
4. Modify ethernet interface boot parameter
0. Return to main menu
Enter your choice(0-4): 2
Step 7: At the prompt displayed in the last step, select a place for retaining the
downloaded file (the Flash for example by entering 2), press , and the system
will display the following information in the terminal:
Attached TCP/IP interface to fei0.
Attaching network interface lo0... done.
boot device : fei0
unit number : 0
processor number : 0
host name : 9500
file name : 9500.app
inet on ethernet (e) : 1.1.1.1
host inet (h) : 1.1.1.2
flags (f) : 0x80
Prepare for loading....OK
Loading......done
flash:/9500.app already exist,
delete it?(Y/N):y
Deleting file--------------------------------------------------------
-------------------------------------------------Done
Free flash Space : 15862784 bytes
Writing Flash--------------------------------------------------------
--------------------------------------------------------------------------
--------------------------------------------Done
Step 8: The information displayed in the last step means a successful file downloading
operation. In this case, the system accesses the Ethernet interface submenu again and
the user can make selection as needed. The details will not be covered here.
ETHERNET SUBMENU
1. Download file to SDRAM through ethernet interface and boot
2. Download file to Flash through ethernet interface