B.2.5 cabinet combination connection – H3C Technologies H3C S9500 Series Switches User Manual
Page 158
Installation Manual
H3C S9500 Series Routing Switches
Appendix B Installation of B68 Cabinet
B-7
(1) Retaining nut of the cabinet
(2) Cabinet foot
(3) Retaining nut of anchor plate
(4) Lower enclosure frame of the cabinet
Figure B-7
Cabinet feet fastening
B.2.5 Cabinet Combination Connection
Note:
If two or more cabinets are used, it is required to combine them. Skip this section if not
necessary.
When combining cabinets, first remove the top covers of the cabinets as shown in
Figure B-8, and then rotate the combining plates on top of the cabinets by 180
o
. After
fastening, use flat washer, spring washer, bolt and nut to connect the combining plates
of two neighbor cabinets, as shown in Figure B-9. Figure B-8 shows the position of the
combining plate before it is rotated, and Figure B-9 shows its position after it has been
rotated.
- H3C S7500E Series Switches H3C S7500 Series Switches H3C S5800 Series Switches H3C S5820X Series Switches H3C S5500 Series Switches H3C S5120 Series Switches H3C S3610[S5510] Series Switches H3C S3600 Series Switches H3C S3100 Series Switches OAA For Routers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSQM1WCMB0 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA2600 Series WLAN Access Points H3C WA2200 Series WLAN Access Points H3C SecPath F1000-E H3C SecPath F1000-A H3C SecPath F1000-S H3C SecPath F100-A H3C SecPath F100-C-EI H3C SecPath V100-E H3C SecCenter iTAS H3C Device Manager