H3C Technologies H3C S9500 Series Switches - Manual (Page 140)

Installation Manual
H3C S9500 Series Routing Switches
Appendix A Engineering Labels for Cables
A-6
I. Signal cable label
1) Affixing the label to the signal cable
The label is affixed 2cm from the connector on the signal cable. In special cases, for
example, to avoid cable bent or affecting other cables, other positions are allowed to
affix the labels.
The steps to affix the label to the cable are shown in Figure A-5, Figure A-6 and Figure
A-7. The finished labels should be on the right or top of the cables, according to
different cabling methods. The left part of the figures shows the method to affix the label
when the cable is laid vertically, while the right part of the figures shows the method to
affix the label when the cable is laid horizontally.
2) Stick the label to the proper position on the cable, fold the narrow part of the label
according to the directions shown in Figure A-5.
Stick side
Fold to right
Cable
Stick side
Fold dow n
Cable
Stick side
Fold to right
Cable
Stick side
Fold dow n
Cable
Stick side
Fold to right
Cable
Stick side
Fold dow n
Cable
Figure A-5 Stick the label onto proper position of the signal cable
The lengh of the narrow part is based on an external cable diameter of 2.6mm, after this
part has been stuck to the back of the label, it may not overlap the entire printed part.
3) Fold the printed part along the dotted line according to the directions shown in
Figure A-6.
Cable
Stick side
Fold up
Cable
Stick side
Fold to right
Cable
Stick side
Fold up
Cable
Stick side
Fold to right
Cable
Stick side
Fold up
Cable
Stick side
Fold to right
Figure A-6 Fold up the label