H3C Technologies H3C S9500 Series Switches - Manual (Page 27)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 1 Product Overview
1-21
The SRP1N6 module provides CF port, CF LED (CFS), 10Base-T/100Base-TX port,
RS232/485 port, Console port, AUX port, RESET button, LPU status LEDs, SRP1N6
status LEDs (SFS, ACT, ALM, RUN), as shown in Figure 1-13.
Figure 1-13 SRP1N6 panel
3) User ports
z
CF port
The SRP1N6 module provides a CF port to accommodate a standard CF card, where
you can save logging information, host version information, alarming and other
diagnostic information and conveniently upgrade software online.
z
Management 10Base-T/100Base-TX port
The management 10Base-T/100Base-TX port uses an RJ-45 connector. It can connect
a background terminal for system program loading and debugging, or connect a
network management station for remote system management.
Table 1-25 Management 10Base-T/100Base-TX port specifications
Attribute Description
Connector RJ-45
Number of ports One
Rate
10 Mbps, half duplex/full duplex
100 Mbps, half duplex/full duplex
Max. transmission segment
over the selected medium 100 m (328 ft) over the category-5 twisted pair
cable (crossover cable is required.)
Service
System program upgrade and network
management
The following table describes the status LEDs for the management
10Base-T/100Base-TX port.