B.4 quakeproof reinforcement of cabinet, I. installing quakeproof angle plate, Figure b-34 – H3C Technologies H3C S9500 Series Switches User Manual
Page 184: Figure b-35
Installation Manual
H3C S9500 Series Routing Switches
Appendix B Installation of B68 Cabinet
B-33
Figure B-35
B68-22 cabinet installation in the equipment room with raised floor
B.4 Quakeproof Reinforcement of Cabinet
Note:
For the areas subject to earthquake risk, in order to improve the quakeproof
performance of the cabinet, reinforcement measures should be followed for the cabinet
according to the following procedures. Skip this section if not necessary.
To reinforce the cabinet, the following procedures should be covered:
I. Installing quakeproof angle plate
Rotate the quakeproof angle plate on the upper enclosure frame of the cabinet by 180º
and then fasten it again. Figure B-36 shows the position of the quakeproof angle plate
before the reinforcement and Figure B-37 shows the position of the quakeproof angle
plate after the reinforcement completes.
- H3C S7500E Series Switches H3C S7500 Series Switches H3C S5800 Series Switches H3C S5820X Series Switches H3C S5500 Series Switches H3C S5120 Series Switches H3C S3610[S5510] Series Switches H3C S3600 Series Switches H3C S3100 Series Switches OAA For Routers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSQM1WCMB0 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module H3C WA2600 Series WLAN Access Points H3C WA2200 Series WLAN Access Points H3C SecPath F1000-E H3C SecPath F1000-A H3C SecPath F1000-S H3C SecPath F100-A H3C SecPath F100-C-EI H3C SecPath V100-E H3C SecCenter iTAS H3C Device Manager