H3C Technologies H3C S9500 Series Switches - Manual (Page 95)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 4 Switch Installation
4-26
RJ-45 Signal DB-9 Signal
5 GND 5 SG
6 RXD 3 TXD
7 DSR 4 DTR
8 CTS 7 RTS
II. Connecting console cable
Take the following
the terminal.
steps to connect the console cable, when configuring the switch on
1) Plug the DB-9 female connector of the console cable into the serial port of the
PC/terminal where the switch is to be configured.
2) Connect the RJ-45 connector of the console cable to the console port of the
switch.
Note:
The PC serial port is not hot-swappable, so you are not allowed to insert or remov
console cable into or from the PC serial port.
When connecting the console cable, first connect the DB9 end to the PC serial po
then the RJ45 end to the console port of the switch. And removing the console ca
just in inverse order.
e the
rt and
ble is
When removing the console cable, first remove the RJ-45 end and then the DB9
g AUX Cable
You need an AUX cable when configuring the S9500 series with the remote m
end.
4.11.2 Connectin
I. Introduction
AUX cable is an 8-core shielded cable. At one end of the cable is an RS-232-compliant
RJ-45 c r that can be into the AUX port of the switch. At end is
DB-9 (male) connector can plug it into ) port of the modem. For
detail, refer to Figure 4-28 and Table 4-2.
II. Connecting AUX cable
1) Plug the RJ-45 con ctor of the AUX c ch.
odem
dial-up approach.
onnecto plugged the other
. You the DB-9 (female
ne able into the AUX port of the swit