H3C Technologies H3C S9500 Series Switches - Manual (Page 32)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 1 Product Overview
1-26
The management 10Base-T/100Base-TX port uses an RJ-45 connector. It can connect
a background terminal for system program loading and debugging, or connect a
network management station for remote system management.
Table 1-34 Management 10Base-T/100Base-TX port specifications
Attribute Description
Connector RJ-45
Number of ports One
Rate
10 Mbps, half duplex/full duplex
100 Mbps, half duplex/full duplex
Max. transmission distance
over the selected medium 100 m (328 ft) over the category-5 twisted pair cable
(crossover cable is required.)
Service System program upgrade and network management
The following table describes the status LEDs for the management
10Base-T/100Base-TX port.
Table 1-35 Status LEDs for the management 10Base-T/100Base-TX port
LED Status
OFF No link is present.
LINK
Green A link is present.
OFF No packets are transmitted/received on the port.
ACT
Orange blinking Packets are being transmitted/received on the port.
z
RS232/485 port
The RS232/485 port uses RJ-45 connector, for connecting external PoE power frame
when supported and monitoring its status.
Table 1-36 RS232/485 port specifications
Attribute Description
Connector RJ-45
Number of ports One RS 232 port and one RS485 port
Service
The port for monitoring and communication with the external
subsystem, such as external PoE power supply module
z
Console port