H3C Technologies H3C S9500 Series Switches - Manual (Page 136)

Installation Manual
H3C S9500 Series Routing Switches
Appendix A Engineering Labels for Cables
A-2
(2)
10.0
84.0
1.5
0.6
2.0
1.0
(1)
11.0
11.0
7.5
7.0
5.5
5.5
5.5
5.5
7.0
7.5
37.0
TO:
(2)
(1)
(1) Dividing line (2) Cut dotted line
Figure A-1 Label for signal cables
The dividing lines on the label help to specify more clearly the position of a cable. For
example, there is one between the cabinet number and the frame number and another
one between the frame number and the slot number. The dividing line is 1.5mm
×0.6mm
in size with the color of PONTONE 656c (light blue).
The cut dotted line helps to fold the label when affixing it to the cable, and its size is
1.0mm
×2.0mm.
There is a mark “TO:” (upside down in the figure) at the lower right corner of the label.
The mark is used to identify the opposite end of the cable on which the label is affixed.
II. Label for power cables
The label for power cables should be attached to the identification plate on the cable
ties that are bundled to the cable. The identification plate has an embossment of
0.2mm
×0.6mm around (symmetric on both sides), and the area in the middle is for
affixing the label, as shown in Figure A-2 (expressed in mm):