H3C Technologies H3C S9500 Series Switches - Manual (Page 30)

Installation Manual
H3C S9500 Series Routing Switches
Chapter 1 Product Overview
1-24
Table 1-31 Status LEDs for LPU modules
LED Status
ON The module is faulty.
OFF The module is faulty or out of position.
Blinking (1s) The module is running normally.
RUN
Fast blinking
(125ms) The module is booting or not registered
successfully.
ON The module has alarms.
ALM
OFF The module has no alarms or is out of position.
2~6 Indicate slots 2 through 6
z
Status LEDs for the SRP1N6 module
You can learn the operating status of SRP1N6 module by reading the SFS, ACT, ALM
and RUN LEDs on it. The following table gives a summary of the four LEDs.
Table 1-32 Status LEDs for the SRP1N6 module
SRP1N6 LED Status
ON The switching fabric unit is active.
SFS
OFF The switching fabric unit is standby.
Green The SRP1N6 module is faulty.
OFF The SRP1N6 module is faulty. RUN
Green blinking The SRP1N6 module runs normally.
Red The SRP1N6 module has alarms.
ALM
OFF The SRP1N6 module has no alarms.
Green The SRP1N6 module is active.
ACT
OFF The SRP1N6 module is standby.
IV. SRP1N7 module
1) Specifications
The S9512, 9508 and 9505 can use SRP1N7 modules, which integrate clock modules
in them. The following table summarizes the specifications.