Toa SX-2000 Series Installation - Manual (Page 98)

98
2.7.4. Replacing the fuse
When a fuse has blown, the corresponding channel status indicator on the unit’s front panel goes out.
In this case, replace the fuse mounted on the channel pc board inside the unit.
Step 1. remove the top panel.
Step 3. replace the top panel.
Step 2. replace the blown fuse on the corresponding channel pc board with a new one.
Note
When replacing the fuse, be sure to use the same Blade-type of fuse, of which rating differs depending
on the models as follows.
VP-3504: 30 A
VP-3304: 20 A
VP-3154: 10 A
Rear side
[Top view (with the top panel removed)]
Channel 1
PC board
Channel 2
PC board
Channel 3
PC board
Channel 4
PC board
Blade-type fuse
30
30
30
30
The figure below shows the VP-3504.