Toa SX-2000 Series Installation - Manual (Page 77)

77
2.5.8. Installing the RM-200SF on a wall
the rm-200Sf is designed for on-wall installation.
[Mounting hardware]
to mount the rm-200Sf on the wall, the following parts are required.
Wall mount bracket unit .............................................................. 1 (supplied with the rm-200Sf)
Wall mounting screws
4 x 25 tapping screw for wooden wall ................................... 2 (supplied with the rm-200Sf)
m3.5 x 20 screw for electrical box ......................................... 2 (supplied with the rm-200Sf)
[Ferrite cable clamp attachment]
the supplied ferrite clamp needs to be attached to the link cable as illustrated below.
As its mounting timing differs depending on the installation way of the rm-200Sf, mount the clamp in the
appropriate installation step.
Ferrite clamp
(Supplied with the RM-200SF)
Loop the cable one turn.
Link cable
RM-200SF
mount the ferrite clamp (supplied with the rm-200Sf) on the
cable in a way that the cable is looped one turn as illustrated.
(this countermeasure is for complying with the cE marking.)