Toa SX-2000 Series Installation - Manual (Page 85)

85
2.5.12. Creating remote microphone name labels
using the SX-2000 Setting Software function, assigned names of preset rm-200Sf, rm-200SA, and rm-
210 function keys can be printed out. once printed, cut out the printed names with scissors to use them as
corresponding name labels. the paper used for the name label must be under 0.2 mm in thickness.
Note
for creating and printing name labels using the SX-2000 Setting Software, see the separate Setting Software
Instructions, "labels for remote microphones."
[Inserting the name label]
• fully insert the name label cut to the instructed size into the label entry slit.
• to remove the label, pull it out of the slit using the tip of knife blade.
Name label entry slit Name label entry slit
RM-200SA
RM-200SF
Name label A
(Created and printed using
the SX-2000 Setting Software)
Name label B
(Created and printed using
the SX-2000 Setting Software)
Name label C
(Created and printed using
the SX-2000 Setting Software)
RM-200SA
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
FIREMAN'S MICROPHONE
RM-200SF
MIC SP CPU
OFF ON
Name label entry slit
Power
Fault
CPU OFF
Emergency
Reset
Evacuation
EV
All Zones
Talk
Zone 6
Zone 7
Zone 8
Zone 9
Zone 10