Toa SX-2000 Series Installation - Manual (Page 151)

151
7. TIME SETTINgS
time, which is recorded in the SX-2000 system's operation log inside the SX-2000Sm, must be set.
Note
the SX-2000Sm's internal battery will retain the set time for approximately one week. If there is a period of
a week or longer between equipment assembly and wiring to on-site installation, it will likely be necessary to
perform the time setting again after the system is installed on the site.
Step 1. connect the SX-2000Sm and the Pc installed with the SX-2000 software to the switching hub.
connect the SX-2000Sm's lAN connection terminal to a 10BASE-t- or 100BASE-tX-compatible
switching hub.
use StP category 5 Standard straight lAN cable fitted with rJ45 connectors.
Notes
• The distance between the SX-2000SM and the switching hub must be less than 100 meters.
• Do not connect the switching hub to the LAN.
• Avoid directly connecting the SX-2000SM to the PC via a cross cable.
SX-2000SM
Switching hub
LAN connection terminal
Straight cable Straight cable
PC with the SX-2000 Setting
Software installed
Step 2. Perform the time setting from a Pc.
for details, see the separate Setting Software Instructions, "Adjusting the time for the SX-2000Sm."