The vp, Power amplifiers – Toa SX-2000 Series Installation User Manual

Page 91

2.6.3. Installing the vp-200vX power Amplifier Input Module in the vp power Amplifiers

Step 1. remove the top panel.

refer to

for removal procedures.

Step 2. using nippers, clip out 4 connecting sections and the plate over the VP-200VX mounting location on

the power amplifier's rear panel.

Notes

• cH1 is not covered with a plate.

• remove only the plate of the channel to be used.

CH3

CH1

CH4

CH2

[VP-2064 Rear]

Cut off with nippers.

Step 3. unscrew the VP-200VX's panel.

Step 4. mount the VP-200VX module.

Attach the VP-200VX 's panel to the mounting location and the VP-200VX unit to the back of the

mounting location, then secure them to the amplifier using the screws removed in Step. 3.

Notes

• Perform installation for lower mounting locations (cH2 and cH4) first.

• mount the VP-200VX with its circuit board components faced down.

VP-200VX

VP-200VX 's panel

Mounting screw

(Use the screw removed

from the VP-200VX)

This manual is related to the following products: