Toa SX-2000 Series Installation - Manual (Page 39)

39
1.9. RM-200SA Remote Microphone
[Top]
RM-200SA
1
3 5
6
7
8
8
10
2 4 6 7 9
11 12 13
1. Microphone
used for voice announcements.
2. power Indicator (green)
lights when the power is turned on.
3. Failure Indicator (Yellow/Red)
flashes yellow if some problem within the system
is detected.
this indicator will light yellow if the signal to the
SX-2000AI or SX-2100AI to which the rm-200SA
is connected is interrupted for 5 seconds or more.
this indicator will light red while the general
urgency all-call is being made ( p. 70 ) or the rm-
200SA is in the reset process.
4. Emergency Indicator (Red)
lights when the SX-2000 system is in an emergency
condition.
5. Emergency/general Urgency All-call Key
(Covered)
When the Emergency Broadcast Pattern Start
function has been assigned to this key by the SX-
2000 Setting Software, pressing it activates the
emergency broadcast from the SX-2000 system.
Independently of settings made by the SX-2000
Setting Software, holding down this key for 4
seconds or more in combination with DIP switch
(14) setting causes the cPu to be bypassed,
enabling the general urgency all-call to be made
by way of analog transmissions. (See p. 70 .)
6. Indication Label Insert Slots
labels can be printed using the SX-2000 Setting
Software. (See the separate Setting Software
Instructions, "Printing labels for remote
microphones.")
7. Status Indicators (Red/Yellow/green)
Light, flash, or go off depending on the current
operation state of function keys, failure state or
emergency state. (See the separate operating
Instructions, "remote microphone rm-200SA,
remote microphone Extension rm-210" and
"operation.")
8. Selection Indicators (green)
light or go off depending on the current operation
state of function keys.
(See the separate operating Instructions, "remote
microphone rm-200SA, remote microphone
Extension rm-210" and "operation.")
9. Function Keys (R1 – R10)
Positioned in top-down order (r1, r2 ... r10).
Pressing a specific function key executes the
function that has been assigned to that key by the
SX-2000 Setting Software.
Assignment of functions to specific keys is done
using the SX-2000 Setting Software. (See the
separate Setting Software Instructions, "Event
Settings.")
RM-200SA