Toa SX-2000 Series Installation - Manual (Page 57)

57
2.3. SX-2000AO and SX-2100AO
2.3.1. Setting the device number
Notes
• When setting the device number for multiple SX-2000AO and SX-2100AO units, assign different numbers to
each unit. the device number that can be used must not exceed the actual number of SX-2000Ao and SX-
2100Ao units set using the SX-2000 Setting Software.
• If a device number is duplicated, then the SX-2000AO and SX-2100AO units assigned that number cannot be
controlled by the SX-2000 system.
Step 1. remove the protective cover on the SX-2000Ao's or SX-2100Ao's front panel by unscrewing it with a
Phillips screwdriver.
Protective cover
Screw
Inside of the protective cover
01234
5678
9AB
CD
EF
01234
5678
9AB
CD
EF
ID switches Reset key
Step 2. Set the ID switches.
Note: the device number is set to No. 1 by default.
Step 3. Press the reset key to reactivate the SX-2000Ao or SX-2100Ao.
Note
reactivating the SX-2000Ao or SX-2100Ao stops broadcasts being made via that SX-2000Ao or SX-
2100Ao unit.
Step 4. replace the protective cover.
Arrowhead
ID NUMBER
A B
Arrowhead
ID NUMBER
A B
Device number
ID switch A 0
0 1 2 3 4 5 6 7 8 9 A B C D E F
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
B
Device number
ID switch A 1
0 1 2 3 4 5 6 7 8 9 A B C D E F
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
B