Toa SX-2000 Series Installation - Manual (Page 150)

150
6. INSERTINg A CF CARD
6.1. Using Settings Data
the SX-2000 system is operated by storing the data set using the SX-2000 Setting Software on a cf card and
inserting the card into the SX-2000Sm.
Note
Be sure to insert the cf card containing the settings data into the cf card slot.
6.2. Inserting a CF Card
(SX-2000SM: DIp switch 2 operation)
the DIP switch must be set when inserting the cf card into the SX-2000Sm.
follow the procedure below:
Note
Do not operate the DIP switch while the cf card access indicator inside the protective cover is flashing.
Step 1. remove the protective cover on the SX-2000Sm's front panel by removing the screws securing it using
a Phillips screwdriver.
CF card access indicator Reset key DIP switch
CF card slot
Screw
Protective cover
Inside of the protective cover
Step 2. Confirm that the CF card access indicator is unlit.
Step 3. Set DIP switch 2 to oN.
Note
DIP switch 2 is set to the off position by default.
Step 4. Insert the cf card containing the settings data into the cf card slot.
then, the buzzer sounds.
Setting DIP switch 2 to off in Step 5 stops the buzzer.
Step 5. Set DIP switch 2 to off.
Step 6. Press the reset key.
the SX-2000 system is reactivated.
Note
reactivating the system stops broadcasts currently in progress.
Step 7. replace the protective cover.
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8