Toa SX-2000 Series Installation - Manual (Page 51)

51
2. INSTALLATION
2.1. SX-2000SM
2.1.1. System reset enable/disable settings (DIp switch 3 operation)
the entire system can be reactivated by pressing the SX-2000Sm's reset key. It is also possible to enable the
entire system to restart through the operation of System reset button on the SX-2000 Setting software.
use the SX-2000Sm's DIP switch 3 to enable or disable the system reset function with the SX-2000 Setting
software.
Note
for the system reset method with the SX-2000 Setting software, see the separate Setting Software Instructions,
"resetting the System.")
Step 1. remove the protective cover on the SX-2000Sm's front panel by unscrewing it with a Phillips screwdriver.
Step 2. Perform DIP switch setting.
2-1. When enabling system reset
Set DIP switch 3 to off.
operation with the System reset button on the
SX-2000 Setting software is enabled.
2-2. When disabling system reset
Set DIP switch 3 to oN.
operation with the System reset button on the
SX-2000 Setting software is disabled.
Step 3. replace the protective cover.
Protective cover
Screw
Inside of the protective cover
DIP switch Reset key
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
Note: DIP switch 3 is set to the off position
by default.