Toa SX-2000 Series Installation - Manual (Page 32)

32
1.6. SX-2000CI Control Input Unit
[Front]
Protective cover
Inside of the protective cover
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8
16
POWER
CPU OFF
FAULT
CONTROL INPUT UNIT SX-2000CI
17
25
18
26
19
27
20
28
21
29
22
30
23
31
24
32
CONTROL INPUT
USB RUN RESET ID NUMBER
012
34
56
789ABC
DEF
SETTING ON
1 2
3 4
5 6 7 8 9
1. Control Input Indicators
[CONTROL INpUT 1 – 32] (green)
light when the corresponding control inputs are
turned oN.
2. power Indicator [pOwER] (Blue)
lights when the power is switched on.
3. CpU OFF Indicator [CpU OFF] (Red)
lights while the general urgency all-call (cPu off
state) is being made ( p. 70 ).
4. FAULT Indicator [FAULT] (Yellow)
lights while the general urgency all-call is being
made ( p. 70 ) or when communications to the
SX-2000Ao or SX-2100Ao are interrupted for 5
seconds or more.
flashes when a failure is detected in the system.
5. USB port [USB]
this port is not used.
6. RUN Indicator [RUN] (green)
Normally flashes continuously.
Goes off while the general urgency all-call is being
made ( p. 70 ).
7. ID Switch [ID NUMBER]
this switch is not used.
Always set to "0."
Note
this switch is set to "0" by default.
8. Reset Key [RESET]
Pressing this key resets the SX-2000cI.
9. DIp Switch [SETTINg]
these switches are not used.
Note
Switches 1 – 8 are set to the off position by
default.
SX-2000CI