Toa SX-2000 Series Installation - Manual (Page 86)

86
Name label A
Cutting size: 30 x 110 mm
Name label B
Cutting size: 30 x 136 mm
Name label C
Cutting size: 29.6 x 118 mm
30
13
13
13
13
118
21
21
21
13
13
13
13
13.5
13.5
136
13 x 9 (=117)
39
110
30 30
[Dimensional diagram for printing devices]
[If the name label is not printed correctly]
the name label created using the SX-2000 Setting Software may not be printed in correct size depending on
the configuration environment of your Pc. In such cases, try one of the methods described below.
(1) Preparation by hand
copy the "Pattern paper for hand writing" on the next page . After writing a name, cut out the pattern paper
aligning it with the cutting guidelines.
(2) Preparation by using a Pc or word processor
Prepare and print according to the instructions given in the "Dimensional diagram for printing devices." then
cut out to the instructed size.