Toa SX-2000 Series Installation - Manual (Page 112)

112
4.3. Output Equipment Connections
4.3.1. Connecting the SX-2000AO to power amplifiers
connect each output channel (broadcast zone) to the corresponding power amplifier.
SX-2000AO
Audio output terminals
12P removable terminal plug
(supplied with the SX-2000AO)
Audio lines (2-core shielded cables)
To each channel's assigned
power amplifier
To each channel's assigned
power amplifier
If the power amplifier to be connected is VP-2000 series, the VP-200VX Power Amplifier Input module is used
as an interface between the amplifier and the SX-2000Ao. for cable connections, refer to the table below.
SX-2000AO’s LINE OUTPUT
H
C
E
VP-200VX’s/VP-3000 series’s
RJ45 connector pin
Pin 1 (Signal +)
Pin 2 (Signal -)
Shield
Note: Do not connect any cable to the unused pins of rJ45.