4ć14, Planning your application chapter 4, Object – Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL User Manual
Page 89: Block transfer i/o usage worksheet (page 2 of 2)

Planning Your Application
Chapter 4
4-14
Figure 4.6
Block Transfer I/O Usage Worksheet
Block Transfer I/O Usage Worksheet (Page 1 of 2)
Application File Name:
Block Transfer File Number: 1 2 3 4 5 (Circle One)
Number of Words:
READ (PLC Inp) or WRITE (PLC Out)
(Circle One)
PLC Bit Numbers
14
13
12
11
10
8
7
6
5
4
3
2
1
0
0
9
15
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Block Transfer I/O Usage Worksheet (Page 2 of 2)
Application File Name:
Block Transfer File Number: 1 2 3 4 5 (Circle One)
Number of Words:
READ (PLC Inp) or WRITE (PLC Out)
(Circle One)
PLC Bit Numbers
14
13
12
11
10
8
7
6
5
4
3
2
1
0
16
9
15
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
Completing the Object Address List and I/O Worksheets
Fill out both the Object Address List and I/O Usage Worksheets for each
dynamic object. Mark on the I/O Usage Worksheet the PLC control bit(s)
that are to be assigned to that object.
Object
Each object must be assigned a type and reference number.
Object Name identifies the object’s purpose. If the object has more than
one address, use the Object Name column to identify the purpose of
each associated PLC address. When you use these names in the
application file they take up memory, so keep them as short as possible.
Object Type specifies which type of object you want, such as a Latched
Input Push Button.
Reference Number is used to assign a unique reference number to each
object in the Object Address List. The object’s PLC address bit(s) must
also be indicated on the I/O Usage Worksheet.