Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 194)

File Operations
Chapter 6
6-20
The other Location Data parameters can be configured through the
Communications menu before downloading, or in the Pass-Through
Download to PanelView window at the time of the transfer. Configurations
defined through the Communications menu are saved with the application
file and picked up automatically at the time of the download.
Configurations defined at the time of download override the configurations
in the application file, but they are temporary, and apply only to the current
PanelBuilder session.
PanelView/PLC DH+ Addresses
To configure the DH+ addresses defining the PanelView terminal location
and save them with the application file, choose Pass-Through
Configuration in the Communications menu.
Figure 6.18
The PassĆThrough Configuration Window
22589
Pass-Through Configuration
PLC DH+ Address Not Used
Local Bridge Address Not Used
Remote Bridge Address Not Used
Quit
Cursor to PLC DH+ Address and press Enter. The following window
opens:
Figure 6.19
PLC DH+ Address Window
22615
PLC DH+ Address
Not Used
PLC DH+ Address (0-77)
Quit
Cursor to PLC DH+ Address (0–77) and press Enter. Type the correct
address (in octal) in the small field that appears and press Enter.
Local Bridge Address/Remote Bridge Address
These fields are only required when you have two DH+ networks joined by
a connecting module or “bridge”. “Not Used” is the default entry in either
field; otherwise, enter the correct address in octal.