Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 251)

Information and Alarm Windows
Chapter 7
7-43
All Msgs (Display All Alarms Mode)
All alarms are listed in the Display All Alarms mode, whether they are
in-alarm or not—including those alarms which have never been in-alarm
since the Accum Time and Qty were last reset. The Alarm Status column
displays ON or OFF to indicate whether an alarm is active.
When you switch modes from Display Active Alarms or Display Past
Alarms, to Display All Alarms, the alarm at the top of the screen stays in
place and the next 15 alarms are displayed.
Figure 7.35
Alarm Status Screen (Display All Alarms Mode)
22608
Change
Mode
Page
Down
Page
Up
Msg Accum Time Alarm 06/22/93 03:44:52 PM
# Qty HH:MM:SS State Message Mode: Display All Messages
1 5 00:02:18 ON This is alarm message 1
2 0 00:00:00 OFF This is alarm message 2
3 0 00:00:00 OFF This is alarm message 3
4 2 00:00:00 OFF This is alarm message 4
5 0 00:00:00 OFF This is alarm message 5
6 0 00:00:00 OFF This is alarm message 6
7 0 00:00:00 OFF This is alarm message 7
Reset
Qty/Time
Print
Status
Line
Down
Additional alarms: Use PageĆUp or PageĆDown to view
Last QTY/TIME Reset occurred at: 06/21/93 14:07:35
To help you differentiate between active and inactive alarms, the Alarm
State text flashes on active alarms.
Past Alarms (Past Alarms Mode)
The Past Alarms display mode shows all alarms that are active or have
been active since the Qty/Accum Time was reset. The Alarm Status
column shows ON or OFF to indicate those alarms which are currently
in-alarm.