Rockwell Automation 2711 PANELBUILDER SOFTWARE USER MANUAL - Manual (Page 188)

File Operations
Chapter 6
6-14
Figure 6.13
The Transfer Menu
22116
MAIN MENU: Develop Transfer Reports Files Setup Exit
MAIN MENU Develop Transfer Reports FilesCopy File Exit Transfer
Download to PanelView (RS-232)
Upload from PanelView (RS-232)
Pass-Through Download to PanelView (DH+ and Remote I/O)
Pass-Through Download to PanelView (DH+ and Remote I/O)
Burn E
Quit
Download to a PanelView Terminal
Select File EXAMPLE1
Directory C:\PDS
Quit
EXAMPLE1 13:37:22 05/28/90 16985 bytes
EXAMPLE2 09:44:10 05/28/90 17201 bytes
EXAMPLE3 11:36:03 05/18/90 17045 bytes
Select File
Download EXAMPLE1
Configure Port COM1
Application Size
Quit
IMPORTANT: If your terminal contains an application file in the User
EPROM, you can still download a different application file, which will
reside in application memory, for temporary use. The file will be erased,
and replaced by the file in the User EPROM memory, at the next
power-up.
If your terminal contains a user EEPROM, downloading to the terminal
will also replace the existing application file in the user EEPROM with the
new application file.
Downloading Considerations
You cannot download a Keypad terminal application file to a Touch
Screen terminal, or a Touch Screen application file to a Keypad
terminal.
You cannot download an application to a terminal whose memory
configuration does not match the “User Memory Limit” set in the
application file, even if there is enough available memory for the file in
the terminal.
You cannot download an application which uses version 5 features to a
version 1, version 2, version 3 or version 4 terminal. The same is true
for all other application versions: you cannot download an application
containing higher version features to a lower version terminal.